Korg Forums

Hello fellow Korgites, it's my first day here.

I once had a Triton Le and in 'combination mode' when I set up splits I could assign various channels to the separate outputs; eg: Bass to the right and piano to mono. That way I could run an outside bass amp or mixing board.

In Kross I'm having a hard time finding the page that assigns channels to outputs.

Can't seem to find a solution in the manual. Any ideas; thanks in advance

From Vancouver, Canada

catjammer wrote:I once had a Triton Le and in 'combination mode' when I set up splits I could assign various channels to the separate outputs; eg: Bass to the right and piano to mono. That way I could run an outside bass amp or mixing board.

In Kross I'm having a hard time finding the page that assigns channels to outputs.

The Pan function will allow you to assign sounds to either the left or right output. Unlike the Triton, you cannot assign sounds to other outputs, because (as you can see from looking at the back panel) the other outputs don't exist on the Kross.