Page 1 of 1
Problem XY + Gate Nanopad 2
Posted: Sat Nov 05, 2016 5:54 pm
by Trakun
Hi everyone! I have a problem with my Nanopad 2. When i touch the XY nanopad it sends only one note ( how can i change it back to scale? ). When i press Gate ARP it is very slow ( how can i change the speed ). Thank you!
Posted: Mon Nov 14, 2016 7:16 pm
by Trakun
nobody knows?
Posted: Mon Nov 14, 2016 8:45 pm
by voip
The Arp speed can be set by double-tapping the Scale/Tap button, in time with the desired tempo. Gate Arp needs to be selected for this to work.
The slowness of the Gate Arp may be the reason why only one note sounds.
.
Posted: Fri Nov 18, 2016 5:41 pm
by Trakun
voip wrote:The Arp speed can be set by double-tapping the Scale/Tap button, in time with the desired tempo. Gate Arp needs to be selected for this to work.
The slowness of the Gate Arp may be the reason why only one note sounds.
.
Thx! I fixed the arp speed but in Touch Scale mode why when i press on XY pad i got only one note? How do i make it default to make flam/rolls?
Posted: Mon Nov 21, 2016 10:13 pm
by voip
Roll type sounds can be obtained by selecting Gate Arp (no other buttons lit), holding down one (or more) of the pads, then using the XY pad to vary velocity and rate of the repeated notes.
.