Korg Forums

BasariStudios wrote:A lot of you know how i get when i buy a new synth, i always come up with few
bugs and i already did on the Kronos...:
1. (Confirmed on 3 KRONOSes by Me):
When using Polysix turning to User, Arabic or other scales it works unproperly,
Notes change Pitch on each different Kit...someone else confirm please?
You can just use a Factory Polysix patch and just change the Scale to it.

I just tried this, and it works properly. I also made a double program of the AL-1 and PolysixEX, and when selecting different scales, the pitches matched between the two EXi.

Note that there are many things which can affect pitch in these EXi; randomization (from the PolysixEX "Analog" parameter, for instance), chorusing, detuning, etc. make it a little more difficult to hear differences between scales.

Hope this helps,

Dan

So the math: One is 7500-8000 and the other is 2500ish. Really, the OASYS was the King of luxury synths.

I love the Kronos, and it is a quality synth. It is so good I will be eBaying a lot of my studio not because of the money, but because it really makes a lot of what I have that unnecessary and wasteful to my workflow. This synth is that amazing.

Build=wise it is better than an M50 and not as good as an OASYS. It is close to say an M3.

Hi Dan, i will do some more detailed tests, i know the Polysix Engine also
and i will check in there too...it was weird that the pitch only on the Polysix
would constantly change on each hit and only on the Scale Affected Notes.

Operaman, i think the M3 is built wayy stronger and better then Kronos.

BasariStudios wrote:Hi Dan, i will do some more detailed tests, i know the Polysix Engine also
and i will check in there too...it was weird that the pitch only on the Polysix
would constantly change on each hit and only on the Scale Affected Notes.

The Analog parameter will cause the pitch to change slightly for each note played. I just tried this again, and the effect seems to be the same for all notes - not just for the more re-tuned ones.

Best regards,

Dan

So I opened the box tonight, turned it on and here's what I get...


System Startup Failed

Please Disconnect any USB devices and restart...



sorry, but I don't have any USB devices attached. My take is a loose connection somewhere. Back to the factory you must go.

Pete.

So, I assume you did a restart and got the same message?