OASYS-PCI analog cable

gridsleep · Post by **gridsleep** » Fri Jan 11, 2019 4:16 pm

I am considering getting an OASYS-PCI but cannot find one that is not missing the analog breakout cable. Does anyone know the signal routing of that cable, and can provide a diagram? If worse comes to worse I will get the card and a PowerMac G4, and meter the DIN8 socket until I figure out the signals. Thanks to anyone who can provide the information. A full OASYS-PCI technical manual would really be nice. I wrote to Korg requesting info a couple of weeks ago but they have yet to reply.

Mike Conway · Post by **Mike Conway** » Sat Jan 12, 2019 12:28 am

This section of the forum is for the OASYS keyboard, but maybe someone knows. You can also ask this question here:

http://www.korgforums.com/forum/phpBB2/ ... m.php?f=12

I don't know if these documents will help, but just in case you haven't seen them, already:

http://i.korg.com/uploads/Support/OASYS ... 630000.pdf

http://i.korg.com/uploads/Support/Oasys ... 500000.pdf

http://i.korg.com/services/products/oas ... _specs.htm

http://i.korg.com/services/products/oas ... _setup.htm

gridsleep · Post by **gridsleep** » Sat Jan 12, 2019 3:21 am

Thanks. I posted here since there is no OASYS-PCI topic.
I already have everything that could be found concerning the OP, except any technical documents which apparently never made their way outside of the design offices. I had an OP in a G4 once several years ago. I have a Z1 and Prophcy, among others, and would like to see if creating new types of synthesis in hardware would be fruitful.