Pitch Shifting Master Effect

peatymasta · Post by **peatymasta** » Thu Feb 15, 2018 11:13 pm

Sorry everyone, I'm a bit of a noob-

I'm trying to use the Pitch Bend master effect on my Korg Kross to shift the pitch of an external instrument. It seems to be working, but it's also "doubling up" and playing the original tone along with the shifted one.

I have the external audio routed to 127 on MFX 1, and I put the pitch shift on MFX 1, and the effect is set to 100% wet, so why is the unshifted sound still getting through with the shifted one?

Biggles · Post by **Biggles** » Thu Feb 15, 2018 11:48 pm

Hello and welcome

If you look on page 69 of the manual you will see a diagram.

It shows the default position of line and inputs to be before the Insert and Master FX.

There is a detailing text section following the diagram on adjusting the settings that should help.

peatymasta · Post by **peatymasta** » Fri Feb 16, 2018 12:09 am

Unfortunately, no dice. The signal path says that the external is being routed to the IFX and MFX. All IFX are off, shouldn't that mean nothing goes through them?

peatymasta · Post by **peatymasta** » Fri Feb 16, 2018 5:15 am

solved it! it was actually my global audio setting routing to BUS, I set both too off