Hello Korg friends,
There was no SQ-1 forum so posted this here. Having fun with my sq1 and monotribe. Pitch and gate working like a charm with CV when I only transmit on one output (A or B).
However when I run A and B parallel on the sq1 with the monotribe. I have a problem with gate. The gate will get triggered(without pitch) by the other output. Eg monotribe on A will get triggered by gate on B.
In this example the gate output from B is transmitted on the gate out A.
In the manual it is explained this is not possible. Would my unit be faulty?
SQ-1 gate issue in parallel mode
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Sounds faulty, but are you really sure that when running in parallel mode channel B is transmitted on gate A?
Note that when all gate buttons are on and all active steps are on as well on both rows, gate A and gate B signal will basically the same.
A cross-check could be
* run a parallel mode
* disable some gate buttons on channel A and B, but make sure they are different.
* alternatively connect the monotribe to channel A and B
* Does it sound different?
Note that when all gate buttons are on and all active steps are on as well on both rows, gate A and gate B signal will basically the same.
A cross-check could be
* run a parallel mode
* disable some gate buttons on channel A and B, but make sure they are different.
* alternatively connect the monotribe to channel A and B
* Does it sound different?
microKORGXL, Kaossilator Pro, monotribe, SQ-1, volca fm, Kross 88 BK
Alesis SR18, Akai Miniak, Fender Strat, Line 6 Spider II 112, Zoom MS-50G
Alesis SR18, Akai Miniak, Fender Strat, Line 6 Spider II 112, Zoom MS-50G