Need help to sequence the kross

Discussion relating to the Korg Electribe products.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
Monokrome
Posts: 15
Joined: Sat Jan 10, 2015 10:43 pm

Need help to sequence the kross

Post by Monokrome »

Hello,
Thank you very much for your living and enriching forum that goes beyond the borders.
I came because I need help with the electribe 2 and the kross.
I would like to sequence the kross with electribe and I can not, I said that I would use the sounds of the most electribe those of kross for rhodes .But I do not understand and when I change the sound kross everything goes wrong and I lose my original pattern unless I put reception filters on short program but I lose electribe..et its sounds :cry:
Does someone could explain me step by step how to perform this action so I can enjoy these dream machines at once?
Thank you very much for your help :)
Monokrome
Posts: 15
Joined: Sat Jan 10, 2015 10:43 pm

Post by Monokrome »

Uuuuup
dutchcow
Senior Member
Posts: 404
Joined: Fri Dec 26, 2014 9:52 am
Location: Mansfield, UK

Post by dutchcow »

The lack of an answer is usually because nobody knows or it is easily found in the manual.

I've had no problems syncing external gear to the e2. Just make sure your midi setup is correct at both ends.
Monokrome
Posts: 15
Joined: Sat Jan 10, 2015 10:43 pm

Post by Monokrome »

My connection is good midi, midi in on the electribe out of kross and midi out on the electribe in the kross.
Then ???
Monokrome
Posts: 15
Joined: Sat Jan 10, 2015 10:43 pm

Post by Monokrome »

One to help me?
Thank you.
SMK
Platinum Member
Posts: 1197
Joined: Sun Nov 26, 2006 10:22 pm
Contact:

Post by SMK »

When you have short on messages on, you will not be receiving the kind of messages you are looking for. Short messages is the most limiting.

When you are sequencing from the Korg Kross chances are that the Kross is sending midi notes over to the Tribe that could be defeating your patterns.

It has been highly recommended that the Electribe 2 should sent over to your other synths, in this case, the Kross.

A lot of what I said is the manual however the manual is poorly written...no surprise there.

I hope this helps.
Korg PX5d
Korg Quad
Korg KP3
Korg DS-10
Korg PadKontrol
Korg K25
Korg Monotron
Korg Electribe 2
Korg Electribe Sampler 2
Roland GK-3A
Roland GI-20
Fishman Triple Play
BC Rich Guitar

My Music
Monokrome
Posts: 15
Joined: Sat Jan 10, 2015 10:43 pm

Post by Monokrome »

Thank you very much, I'm going to transfer my problem in the topic workstation, good evening.
Post Reply

Return to “Korg Electribe”