Working with the Audio In oscillator on the electribe2

[roblabs]

Note: You CAN have Audio In Thru when using Audio In as an oscillator.

You might hear the Thru louder than the oscillator, unless you've got a latched 127 velocity with some level gain. But with some cleverness it should mask pattern changes, since Thru is not affected by pattern changes.

that's a good tip, Ted, thanks!

[Because789]

Indeed a very interesting discovery! I just tested it with the BSII connected and got in no time some exciting results. Thanks again Ted!

[Yahtef]

Korg, if you're listening, here's a suggestion. Add a few more audio input modes.

Audio Thru 1: Passes stereo audio directly to outputs, bypassing synth and effects engine, mixed with electribe's output. (current behavior)

Audio Thru 2: Routes stereo audio to Master Effect section, but not to synth or insert section.

Audio In 1: Oscillator audio source that goes through synth and both effect sections. (current behavior)

Audio In 2: Oscillator audio source passes through filter, insert effects, master effect - but not amp. Amp gate is latched open without the need to input notes or hold down a pad.

+1 !!!