Volca Keys & MicroKontrol

FinnGerblast · Post by **FinnGerblast** » Sun Aug 24, 2014 10:22 am

Hi folks,

I've recently bought a Volca Keys, which I'm planning on attaching to my MicroKontrol to make an analogue monster.However, the synth isnt responding to anything other than notes or velocity from the micro. As someone who doesn't speak MIDI, how do I remedy this?

dog01 · Post by **dog01** » Mon Aug 25, 2014 11:41 am

hi FinnGerblast you needed to follow the info set out in the microkontrol manual on page 25 and then change the encoders and sliders to theses values
cc5 PORTAMENTO 0-127
cc40 VOICE 0-127
cc41 octave buttons 0-127
cc42 detune 0-127
cc43 VCO EG INT 0-127
cc44 CUTOFF 0-127
cc45 VCF EG INT 0-127
cc46 LFO RATE 0-127
cc47 LFO PITCH INT 0-127
cc48 LFO CUTOFF INT 0-127
cc49 EG ATTACK 0-127
cc50 EG DECAY/RELEASE 0-127
cc51 EG SUSTAIN 0-127
cc52 DELAY TIME 0-127
cc53 DELAY FEEDBACK 0-127

hope that helps if this not enough info then i would youtube anything you don't understand regards dog01

dog01 · Post by **dog01** » Mon Aug 25, 2014 11:58 am

i forgot to include these links which should be of some help

http://macdownload.informer.com/microko ... librarian/

http://i.korg.com/SupportPage.aspx?productid=511

if you use the editor you can ignore the 0-127 and just put the cc numbers in

FinnGerblast · Post by **FinnGerblast** » Mon Aug 25, 2014 3:03 pm

Thanks folks,

It was an easy fix in the end. Both the keyboard and synth were set to channel 10 somehow, set both to 1 and, like magic its sorted!