Groove tubes Ecc83 ... they came at last ......

[Aciphecs]

I put GT ECC83S tubes in my ESX.

[Mazash]

Hi !

One question : if I plug the two stereo outs of the emx equipped with new tubes, to the ins of a kaosspad (3 for exemple) will it "kill" the quality of the tubes even if no effect is applied ?

[0same]

hi, i new to all this, just wanted to say thanks for the grate info.

so if i were to get a pair of "Genalex Gold Lion 'KT series' Tubes"
would they work?

thanks...

o and i found this, my be useful


EMX-1/ESX-1 Tube Calibration
１．Connect the stereo plug of the cable (see fig.) to PHONES and the monaural plug to
INPUT.
2. While pressing ERACE and STEP EDIT, turn the power on. “Valv Wup” is
indicated as stand-by for pre-heating, and also the waiting time is indicated.
Set up the volume knob and switches as follows:
MASTER VOLUME : MAX
TUBE GAIN : MIN
AUDIO IN LEVEL : MAX
MIC/LINE : MIC
3. “Ajst (L)” and a 4 digits figure are indicated in the LCD. If the value is leas than
0010, the test is O.K.. Press the 16 knob at the right bottom. If the value is over it, it is
required to adjust the valve. Adjust the variable resistors which correspond to the
channels referring to the photo below.





4. As well as　“Ajst(L)”, “Ajst (R)” and a 4 digits figure are indicated in the LCD.
If the value is leas than 0010, the test is O.K.. Press the 16 knob at the right bottom. If
the value is over it, it is required to adjust the valve. Adjust the variable resistors
which correspond to the channels referring to the photo above.
5. Once the balance of L/R is automatically adjusted, “ValvGMax GainMx” is
indicated in the LCD. Turn the TUBE GAIN knob to MAX, and press the 16 knob.
6. Check the L/R balance of TUBE GAIN MAX, and return to the normal mode.[/img]