Korg Forums

I would love to get my hands on a hang drum one day but until then this patch rocks.

Thanks,

downloaded the manual this morning, thanks Bertotti and with a little practice I hope to one day be as elite on the WD as Kaden.

I'll do that this weekend, out of town at the moment on biz. Had a moment today and thought I would spark up a discussion on where I left off in the manual. I just got the WD...love it so far as well as the info in this forum........although a bit taken back by Kaden's responce. Didn't expect that ...

okay, now that I have my sound system in check I have to learn the drum. I'm trying to access the wavedrum pcm instruments...listed on the backside of my Voice Name List. Say I want a Tambourine (37 rim) - how do I dial that up?

It sounds amazing with tons of control and sensitivity! I can literally make the floor rumble with a finger tip and I barely have it turned up! The snare stand is a PEARL DRUMS model from the 90s. I added the 3 clamps to the basket arms (also made by PEARL) a few years back to better fit my 10" and ...

I haven't added the box yet...I've just seen direct boxes used this way with live Vdrum setups. I might not even need one...we'll see when I hook it all up this weekend.

I'm gonna add a DI box between the Wavedrum and mixer to eliminate any chance of noise. I run one monitor wedge per output from the amp so it will be presenting an 8ohm load to each side and getting 300 watts output per wedge. The sub has a built in crossover, so the hi-pass is turned on so the ...

Looking deeper into all the manuals I can run the signal out of the WD, into the mixer IN, OUT to the sub, IN the amp, OUT to the monitor wedges.

I'm probably gonna piss my neighbors off big time.

I assume the sub has it's own crossover? How many line outs does you board have or do the speakers have a line through? Some subs take the signal first then pass it to the speaker. Probably best to download the sub and board and speaker manuals to see how to hook them up? There are 2 line outs ...

Thanks for the info...this is what I have in mind for a set up...will it work? Wavedrum into... Behringer Xenyx 802 mixer 6 channel mixer Mackie M-1400I FR amp, 700 watts per channel into 2 ohms, 1400 watts bridged Mono 2X Community Sound MVP12M 12" Monitor Loudspeakers Mackie SWA1501 Active High ...

Hi, I just ordered the 2nd Gen WD. I'm not a sound guy but I do have a few pieces of gear I can use for sound. I have a 15" mackie powered sub and 2 non powered monitor wedges w/ cables. What additional gear should I add to have a good set up for live gigs? I'm sure I'll need...a small mixer and amp ...