Korg Forums

Hi there. Have found a couple more bugs in Progenie 1.75. 1.The Prophecy needs to be in "Performance Mode" and not "Edit Mode" for the "Current Patch" +/- controls to sync/work in Progenie. Make sure the Prophecy Global parameter GLB-15 SysEX Filter>Transmit is set to "On" and the "PE Define" button ...

Hi peeps. Resetting the Master Tune to 440.0 hz after Progenie has changed it to 431.8 hz can be quite tricky using the Prophecy's control knob so here is a better way of achieving the same result. Using SendSX is ideal for this little task so fire it up and add the following string into it's midi ...

In my previous post I said "It appears that the Prophecy does not allow the Global parameters to be sent individually. They have to be sent as a sysex package". This was incorrect. Each Global parameter can be sent individually by using single parameter changes. To change the Master Tune to 440.0 hz ...

It appears that the Prophecy does not allow the Global parameters to be sent individually. They have to be sent as a sysex package. In my case the sysex message is 663 bytes long. The best thing to do is setup the global parameters as you wish and then do a sysex dump from the Prophecy hardware to a ...

I've been a proud owner of a Korg Z1 since around 1999 but out of interest I've recently purchased a Korg Prophecy, my main reason being comparing the difference in their audio outs. The main difference between the two is the multi-timbrality and the extra models in the Z1 but here I'm just ...

Hi there. Does anyone know the sysex message to send to the Prophecy to change the Global Tuning parameter to 440.0 hz. Thanks for any help. Z1 Muso.

Hi. I've noticed when using the Progenie editor for the Korg Prophecy, the software when starting up always resets the Global Tune to 431.8 khz. I've tracked the problem down to the Progenie software rather than being a problem with the hardware. Please could someone confirm this behaviour and post ...

Thanks for your reply OpAmp and I think you're right and the problem is with Korg's midi implementation. I have an old software editor from 1999 for the Z1 called "Zed" created by nooloop. It's abandonware now and has a few flaws but it has some very powerful features so it was worth looking at the ...

I've recently started using my Korg Z1 once again with SoundDiver but have noticed there appears to be no way to switch the Oscillators on/off using the software. The only way I can see is to manually switch them on/off via the hardware and then store the status. In the Midi implementation for the ...

(2) PROGRAM DATA DUMP REQUEST R +----------------+--------------------------------------------------------+ | Byte | Description | +----------------+--------------------------------------------------------+ | F0,42,3g,46 | EXCLUSIVE HEADER | | 0001 1100 (1C) | PROGRAM DATA DUMP REQUEST 1CH | | 00uu ...