Oasys multisamlpes to programs

rowaero · Post by **rowaero** » Mon May 12, 2014 12:02 pm

Hi
I'm new to korg OS and I'm having trouble converting multisamlpes to program's on my oasys
It works fine however after powering down the sample is missing from the program ,I have read the manual and following the instructions the best I can but still no joy

Any help on this would be greatly appreciated

SanderXpander · Post by **SanderXpander** » Mon May 12, 2014 12:29 pm

Samples are kept in RAM, you will need to save your samples to disk and load the KSC file after booting up.

rowaero · Post by **rowaero** » Mon May 12, 2014 3:33 pm

Cheers for the reply. I have the samples saved in the Internal HD but when i load them im not sure as to where they are going? should they play in the program once loaded into RAM from the HD ? the samples were converted to Program and when i powercyle the board the program name is still there but the samples are not sounding, So i have to load the sample file to the program or ?

apologies for the lack of knowledge here i guess i just thought it would be simpler

SanderXpander · Post by **SanderXpander** » Mon May 12, 2014 3:46 pm

If you load just the KSC file (the samples and indexes) the programs will find them in RAM automatically.

rowaero · Post by **rowaero** » Mon May 12, 2014 7:56 pm

Sounds like a plan, thanks for the guidance on this one

Cheers

SanderXpander · Post by **SanderXpander** » Mon May 12, 2014 8:32 pm

In the future, you may get more replies in the Oasys forum. Or even the Kronos one, since they're similar in many respects.

rowaero · Post by **rowaero** » Mon May 12, 2014 8:34 pm

Cheers mate,will do

Korg Forums

Oasys multisamlpes to programs

Oasys multisamlpes to programs

oasys samples

samples