Sequencer: Change pitch as midi event

[salomao]

Hello

Is there any weay I can chanche the pitch of one ore more tracks at a certain point of the sequence?

For example, I would like track 2, 3 and 4 to play upward by one full step (2 semitones) after measure 40. Is there any midi event I can create or edit so that these tracks behave that way?

Of course I could set the pitch at +2 in track properties, but it would affect that track during all song. I just want the pitch change to occur after measure 40.

Is that possible?

Thank you a lot

Salomao

[Daveg181]

Yes, it is possible. Page 1113 of the E6 Parameter Guide (*2 RPN Registered Parameter Number) shows this, but briefly:
Choose which track you wish to edit then on the Track Edit page:

Choose MIDI Event Edit from drop down menu
Leave all the boxes highlighted on Set Event Filters pop up box, press OK
Scroll to the line or measure you wish to Transpose
Press Insert tab 3 times and amend the lines as follows:

In Event Data on the first line: highlight C-1 and use scroll wheel until CNTL is highlighted, change CC# to 100 and Value: 002
Do the same for the next two lines with the following:
CC# to 101 and Value: 000
CC# to 006 and Value: 066 (If +2 semitones)
Ensure that the detail is inputted in the order as above

If you want to revert back to original pitch, insert 3 lines again at the measure/line you require but change the CC#006 Value to 064.

Obviously, this has to be done to each individual track for each Transpose you wish to change to.

Page 1113 shows the detail in more depth.

Hope it helps

[Mike Conway]

Track Edit - SHIFT/ERASE NOTE can shift pitch for as many measures as you like.