Korg Forums

hello everyone
I have just bought second hand Zero 8 mixer. I would like someone to help me in programming the midi controllers to be able to control my DAW from the Korg,
thanks in advance

Hi Nano Squarez,

here you can download the Zero 8 manual
http://www.korg.com/services/downloads/ ... 8_OM_E.pdf
Look for "Using the ZERO8 as a MIDI controller" and
for configuration "MIDI control change message settings",
If you have problems i will help you further.

Best regards
Marxon

thanks Marxon,
I figure out how to use the Midi controllers in banks A, B, C, & D, but if you have the output the channel in MIDI my question is :

how you set up the MIDI controllers, for EXT 1, EXT 2 etc knobs,

thanks again
nano

Hi again,

NANO SUAREZ wrote:thanks Marxon,
how you set up the MIDI controllers, for EXT 1, EXT 2 etc knobs,
nano

Ok, this is really a little bit hidden in the manual...
Search for "Using the controllers of the mixer channels as MIDI controllers"
you have to use the Zero Edit software to set up these controllers.
For communication "Zero Port 1" must be set as Midi in- and output.

Best regards
Marxon