Page 1 of 1
I have two kronoses transfer data.
Posted: Wed Jul 31, 2013 11:48 pm
by Hexfix93
I want to load all setting and sounds from one into another.
It is not working at all. it loads but will not save and auto load as ksc files.. says path not found..
Transfere between two Kronos
Posted: Thu Aug 01, 2013 12:51 am
by scotkeys
I do this regularly its easy just copy the .KSC file of your user samples along with the useBank file.KSC and the folder you named your sample files when you saved them. Once you have the files on the Kronos you want to copy to's hard drive go to GLOBAL settings and tap the KSC auto load tab. tab add ksc button and find the KSC file on your hard drive you copied select that and the file should autoload your user samples when you power up. If you already see the sample file you wanted to autoload in the list it can cause the path not found error . When I see the path not found error I remove the file from the KSC auto lab tab list and replace it using the above procedure and that seems to fix it . Hope you get it going
Posted: Thu Aug 01, 2013 7:27 pm
by Hexfix93
Ok my problem is worse now.
I can get stuff laoded in, but when i save it, it never can load it in from the boot loader, when i go to my patches the samples are not connected to them, even though they are in ram, they work before i save the, then they dont load..