Page 1 of 1
write protect (microkorg xl)
Posted: Wed Apr 08, 2009 2:29 am
by mrchism
i just got the microkorg xl.. i have no idea what's going on. i'm trying to save a preset i edited. click "write".. it says "write program".. hit write again and i get a "error wrtprtct". how the hell do i turn off write protect? the owner's manual just says turn it off.. but doesnt tell how to. haha wtf a little help please?
Posted: Wed Apr 08, 2009 3:04 am
by xmlguy
Turn the [Knob Function Select] dial to Full Edit.
Turn [Knob1] to the Global Page
Turn [Knob2] to the PROTECT parameter
Turn [Knob3] to ON.
Then follow page 31 to write the Global data.
I should point out that I don't have an MKXL. I got all this from the manual.
Posted: Mon Apr 20, 2009 12:56 am
by leavesfrozen
I'm confused about this too. There doesn't seem to be a "Protect" page under global options. The manual does not explain how to do this.
same problem here
Posted: Sun May 03, 2009 6:15 pm
by Petter
i don't get it? WHERE/HOW do i turn off the write protect?
somebody must know, eh?
thx. P
found the answer to this...
Posted: Tue May 05, 2009 12:30 pm
by Petter
Set the main dial to full edit.
Turn the first Page knob to global Mst Tune.
Turn the second parameter knob.
Turn the third value knob to off.
It's not in MY manual
Posted: Mon May 11, 2009 4:33 pm
by Reesa
Thank you VERY much!
This is not in the PDF manual downloaded from the Korg site. My synth is brand new and I was going nuts trying to figure this out.