Korg Forums

Hello,

i just purchased a used Radias expander, in mint condition but it appears the data entry knob - big white wheel at the right of the screen - is unreliable, skipping several steps at a sudden, and making editing a bit awkward.

Have you guys faced a similar situation already and do you know a remedy to this - if that exists... i upgraded to V2.0 (BTW the USR and PGM still show 1.01 for some reason), hoping this would cure the disease a bit, but it did not change anything in that area.

Your feedback and advice will be greatly appreciated

Cheers

Philippe

maybe the wheel is broke?

my wheel on the radias broke and I had it repaired.

it caused everything to skip back and forth.

Hi philippe,

its a hardware problem. I sent my radias to orkg for repair and they replaced whatever is behind the white wheel


Ciao, Dirk.