Korg Forums

Hey all, quick question in case there's something I'm missing in the manual. Is it possible to select a muted part on the EMX-1, without causing that part to unmute when you select it?

unfortunately not

Thanks.

If you select the part before muting it, it will remain selected after you mute it.

My issue is that I usually save my patterns with most parts muted, espcially my leads. I want to leave those muted while matching the knobs with the saved values for more seamless tweaking once I unmute those parts. Seems like it's not possible though, oh well.

There's another workaround.

Don't mute all the parts using mute. Change them to OutBus 3/4 to mute them.

Then you can use select and mute however you want, and then change the part back to OutBus to 1/2 when you're ready to tweak away.

aah ya(duh) or turn the volume all the way down

doesn't shift+pressing the part selects it without sounding/unmuting it?

m4m wrote:doesn't shift+pressing the part selects it without sounding/unmuting it?

Nope, tried that first

yeah no, unfortunatly it only activates it without triggerint it.

my tip is, buy the midi controler, i have simple controler behringer bcr 2000, it is not coastfull. But if u will be have midi cotroler, u can program it to send midi signals to electribe, without chenging selected part to control cut of or wath do u want, everything u wilol be have in controler from front panel.

[quote="drpsycho"]my tip is, buy the midi controler, i have simple controler behringer bcr 2000, it is not coastfull. But if u will be have midi cotroler, u can program it to send midi signals to electribe, without chenging selected part to control cut of or wath do u want, everything u wilol be have in controler from front panel.[/quote]

I have a two midi controllers:
- Korg microKontrol
- M-Audio Ozone

any familiar with how I could either of these to select a particular part?
Is it a controller # for a particular synth part?

They respond to different midi channels, part 1 is channel 1, part 2 channel 2, etc. You can change this in the EMX's midi menu if you want. Drums are always on Channel 10 though I believe, same as the midi standard.