volume on combinations--accross the board

elsurfjetH · Post by **elsurfjetH** » Sat Nov 03, 2007 1:42 pm

Hello all,
I have been using the TR for over 1 year, and the band mates tell me volume varies all over the place with my combinations which have been set up sequentially per gig.
When I verified them stepping through each, I found that from organ to strings, to brass , piano, it is not consistent. As well, on some, I do not have enough even if O move the slider all the way up.

Is there an overall master voluem set that I can use to equate most of these, or do I have to go to each cmobination, and reset all the individual volumes of the (up to) 8 programs in each combination.

I have played with the 3 sliders in the mfx eq gain, but I am distorting the creations.

Or,
Please tell me which of the 3 TR books will give me the answer.
many thanks

Voltan · Post by **Voltan** » Sat Nov 03, 2007 2:16 pm

I'm afraid adjusting individual volumes is the only answer

higskies · Post by **higskies** » Sun Nov 04, 2007 2:56 am

or adding a compressor/limiter in the fx chain and using the output gain to control the overall sound. You'd have to assign all of the voices to the effect, though.