Hello,
I hope someone can help me.
I'm going to have my M1 serviced and before doing so I'm going to Dump all data from the M1 to my computer via MIDI.
I regularly perform the Dump but I haven't had to restore in over 10 years when I changed the button battery and have forgotten how that's done.
Can anyone help me?
Thanks! Ed
Korg M1 dump and restore
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
The procedure to reload the M1 is:
1. Connect the MIDI OUT socket from your PC/sequencer to the MIDI IN socket on the M1.
2. Switch on the M1 and set the basic MIDI channel to 1 (Global Midi Channel) and ensure that SYS-EX RECEIVE is enabled. (if you fail to do this, the reload procedure will not work!).
3. Load the reload file into your PC/sequencer (m1preld.mid or m1preld.syx) and transmit it to the M1.
4. When all data has been transmitted switch off the M1, then switch it back on again and check that the first program sound is I00: Universe.
5. All factory sounds and demos have now been restored.
.
1. Connect the MIDI OUT socket from your PC/sequencer to the MIDI IN socket on the M1.
2. Switch on the M1 and set the basic MIDI channel to 1 (Global Midi Channel) and ensure that SYS-EX RECEIVE is enabled. (if you fail to do this, the reload procedure will not work!).
3. Load the reload file into your PC/sequencer (m1preld.mid or m1preld.syx) and transmit it to the M1.
4. When all data has been transmitted switch off the M1, then switch it back on again and check that the first program sound is I00: Universe.
5. All factory sounds and demos have now been restored.
.