Monologue Program/Value does not work for some edit cases
Posted: Thu Sep 30, 2021 9:49 pm
Monologue number buttons + Program/Value combination does not work for some edit cases
Specifically:
Motion Enable
Motion Smooth
Example:
1. Select Init program
2. Go to Seq Edit menu
3. Select any of the Motion Smooth/Motion Clear menus
4. Neither pressing the corresponding button (11 or 12), nor turning Program/Value knob lets to enable motion, display looks like following:
[MOTION ENABLE]
1:-----
2:-----
etc
Another case is for User Scale and User Octave: after pressing button 10 (scale), scale number shown changes, but after circling to previously changed value, it is not stored.
I have the last firmware, 2.0. My unit fell once from about 80 cm height, but I've been using it since that for about a year and never noticed any malfunctioning except aforementioned ones.
P.S. This is my first post here, nice to meet you all!
Specifically:
Motion Enable
Motion Smooth
Example:
1. Select Init program
2. Go to Seq Edit menu
3. Select any of the Motion Smooth/Motion Clear menus
4. Neither pressing the corresponding button (11 or 12), nor turning Program/Value knob lets to enable motion, display looks like following:
[MOTION ENABLE]
1:-----
2:-----
etc
Another case is for User Scale and User Octave: after pressing button 10 (scale), scale number shown changes, but after circling to previously changed value, it is not stored.
I have the last firmware, 2.0. My unit fell once from about 80 cm height, but I've been using it since that for about a year and never noticed any malfunctioning except aforementioned ones.
P.S. This is my first post here, nice to meet you all!