Page 1 of 1

onboard speakers and voice

Posted: Wed Oct 10, 2018 11:19 pm
by Chuck
I've read the guidance in the manual but fail to find where I can have the vocals come through the onboard speakers. The microphone is connected properly but still no vocals coming through the speakers. Any ideas?

Posted: Sat Oct 13, 2018 11:29 am
by ORGANGRINDER
Did you turn up the volume knob in the back of the keyboard next to the mic input. If that is on go to global/audio /speakers/on - off
push button that says mic on right side of keyboard.
MEL

Posted: Sat Oct 13, 2018 12:35 pm
by Chuck
Thanks Mel. Yep the knob is turned up and we are getting music thru the speakers but no vocals. Maybe it is not to be. :?

Posted: Sat Oct 13, 2018 4:00 pm
by ORGANGRINDER
you must use a dynamic mic not a condenser mic and cord must be xlr to 1/4 mono cord unbalanced. also check audio inputs on gobal and see if mic routing
is to left and right. My guess is it's the mic. even a cheap mic will work to let you know if you are connected properly and the light in the mic section should flash to tell you if you are getting a signal.
MEL

Posted: Sat Oct 13, 2018 4:08 pm
by Chuck
You may be on to something. I'll get after that and see what happens, Thanks again. :)