Page 2 of 2
Posted: Mon Dec 22, 2008 12:11 pm
by klangsulfat
jerrythek wrote:So this is the first phase of the investigation. If you are having problems look at your interface first, and please report exactly what you are using in these threads so we can better understand.
Strange. Regarding my investigations, the issue seems to be introduced with 10.5.5. My Midisport 1x1 and my CME U2M are working fine with the Microkorg editor before 10.5.5.
microKorg Connectivity
Posted: Thu Jan 22, 2009 6:40 am
by leisure
I am using an MAudio FireWire 410 as the midi interface with my microKorg and Intel macbook 2.4 Duo...I can control things like Reason fine via Midi... Also Midi and write protect is set correct on the mK but when I go to dump data (receive) on to my mac all the programs show up blank...
The editing that can be done over mac/pc is more extensive than what can be done with the knobs on the front of the mK - is this assumption correct?
Before I invest in a cheap usb solution I'd like to get this to work over firewire if possible - any suggestions?
Thanks all.
Posted: Sat Mar 14, 2009 12:10 pm
by xsic
the editor won`t work with the rme fireface 400 interface.
it works with evolution ev-10 midi-interface.
i´m on macbook, leopard 10.5.6.
just to share.
regards
manu
Posted: Sun Aug 23, 2015 9:34 am
by juliocam
I have a similar issue using the Roland USB UM-1 on OSX Yosemite.
Using SoundEditor, I can receive the data from the microkorg (the screen lights in the mk flash and I receive all the info in SoundEditor), however, when I transmit data to the microkorg the lights on the microkorg don't move and I get the error: MIDI Error microKORG didn't respond
I followed all the steps in the manual:
- Write Proteccion Off
- Internal Clock EXT
- Midi Filter System Exclusive Enabled
Thanks a lot!
Posted: Mon Jan 18, 2016 1:44 pm
by mlale
Posted: Sun Nov 13, 2016 4:47 pm
by pauloakio
I've got a similar problem, except by that I use Windows 10 and a Prelude Conecta Interface.
The sound editor recognizes the interface and Microkorg, but when I try to edit a program, the software stops working.
Posted: Fri Dec 30, 2016 2:54 am
by RajiRabbit
Got it to work buy purchasing a simple iconnectivity MIO
Even though everything looked fine until the end, when I was using the i/o on my Maschine Controller... It never played nice with my Kontrol S49 ports either.
However this dedicated midi interface did the trick, and wasn't expensive.
Korg support was unreachable as it was after christmas and not yet the new year.
So if this happens to you , it's probably some unexplainable madness but the MIO fixes it