Page 10 of 10

Posted: Thu Oct 06, 2011 11:17 am
by Pastor-of-Muppets
You get a cable which has the right kind of plug for your monotribe at one end, and the right kind of plug for your interface at the other end. Then you plug it in.

Posted: Fri Oct 07, 2011 8:52 pm
by geddy
geddy wrote:Hello, I have just purchased a Korg Montribe and I love it. I have been playing with the beast for a good few hours now using the in-built speaker, as well as listening through the headphone jack.

I have now got to a point where I would like the record the audio into my DAW/listen through my KRK RP5 monitors. The Monotribe does have an output jack and the manual explains how to connect it up:
(page 8) 4. OUTPUT jack
Connect the monotribes OUTPUT jack to the INPUT hack of your mixer or powered monitor speakers. The output signal is monaural, but the jack will accept either monaural phone plugs or stereo phono plugs (unbalanced)
I currently have an Audio Kontrol 1 audio interface which has a MIC/LINE input connecting to my macbook.

Could anyone help me and advise me on any connectors that I may need to get the Montribe to run through my DAW/speakers please?

Much appreciated!
I did have the correct wires after all, just that they were faulty which I did not know about!

They had a weird response where I only got signal if the 1/4" was slightly pulled out of the Audio OUT socket. I ended up swapping to a cheaper set of wires which allowed the connection to work perfectly.

Posted: Mon Oct 29, 2012 8:31 pm
by Mikeeee
this might help, though I don't have a monotribe even though I am aware it uses standard 1/4 inch jacks for audio.
I use M-audio Delta66 for a lot of things including feeding audio into my computer using Ableton live. Then feeding out to 4 separate amps and speakers. It works brilliantly.


http://www.m-audio.com/products/en_us/Delta66.html