M3 realtime control sequencer

[cyros1]

Hello could anybody tell me if it is possible to have realtime control over paramaters i.e. filters on a programme while in sequencer mode, so If I select track 1 can I have control of that programme like I can in programme mode?

And if it is possible can the parameters be controled by a seperate midi controler i.e. foot switches, pedal

Thanks

[Bald Eagle]

You can assign the real time controllers and SW1 & SW2 in Sequencer mode on P1:DT/XY/Ctrls.

You can also use Tone Adjust which is much more flexible and probably what you are looking for. Go to P0-2:Play/REC and select the Control Surface Tab. Change the Control Assign setting to Tone Adjust. Then select the track you want to control. From there you can setup the sliders and switches as needed.

Foot pedal assignents are set up in Global mode P2:Controllers but you don't get a lot of choices there.

[cyros1]

Thanks bald eagle I will check it out, idealy I would like to move through filter cut or reso with a midi foot controller i have a beringer 1010 I would like to use the pedals on that, trying to keep my hands free, the M3 needs a midi learn lol,

[Bald Eagle]

I haven't tried this but I think it should work. Assign the foot pedal to one of the RT Sliders. Setup that slider the way you want. Then the foot pedal will duplicate what the slider does.

[SanderXpander]

Setting the pedal to CC#74 (cutoff) or 71 (resonance) should work as well. It would be channel dependent though, depending on what you need that could be either good or bad.

[cyros1]

Thanks for your help guys, the other thing I would like to control is the rotary speaker effect speed for organs and I think there is an assignment for that in the effect, I need to use my m3 for some live work and its getting pretty complicated I have a 12 step for some chords and bass, m audio 88 controller up to 3 splits on the m3 73 and I am using it all through the sequencer and its working good, I have learned alot