New to M3 - Only one timbre works in a combi

rkirby · Post by **rkirby** » Sat May 09, 2009 4:36 pm

I'm new to workstations and all of this stuff, but I just can't get past something this simple.
I was creating a new combi. I added the first timbre everything is fine. I add the second timbre and it just will not react. When I strike a key the blue bar is shown normal for the first timbre, but no reaction on the second timbre. It's not muted, and everything looks like the first one. I know this is an elementary question, but can some one help me?

Thanks

BasariStudios · Post by **BasariStudios** » Sat May 09, 2009 4:59 pm

Hit the Menu button and sellect P3 Timbre Param page, in the under the MIDI
1-8 or 9-16 page switch the MIDI channels to Gch, on the tracks you wanna use.

rkirby · Post by **rkirby** » Sat May 09, 2009 5:16 pm

Thanks so much.