oscillator 2 knob jitters

acertainpoint · Post by **acertainpoint** » Sun Nov 30, 2008 6:45 pm

Ok, so i made a post not too long ago about my emx acting goofy, well it did it again yesterday..

i was just running through the menu to change to length and all the sudden my oscillator 2 menu came up

it happened so quick, i couldnt tell if it changed any values

it happened about four times in a random sucession for like 3 minutes.

is this something to be worried about? oir should i just wait a little bit longer before freaking out entirely

you see, im worried im going to pay and get this fixed, waste the money, and the service center not fix the problem at all.

i dont know if i should wait, go the route of fixing it, or just say #^!& it and buy a new emx

harvestein · Post by **harvestein** » Mon Dec 01, 2008 1:55 pm

it will be the dial after all then. Better get the soldering iron out pal.

Ruso said he has spare POTs so maybe you could ask him.
I wish i had the money to just 'buy a new one'!