technical "Chord" question

[mikael]

Hello!

I wonder how I can make a "BAS" sound just to sound
when I play the first tagnent down....and not all of the three tagnents when doing a chord with the left hand?

When I make a chord I play three tagnents down
but I do not know how to adjust the "BAS" so it will
sound one time and not three times?
(Because it sounds like the speakers will explode)

Thank you
for help!
Mikael

[orpheus2006]

What?
Sorry, but I really don't understand your question.

What's "tagnents"?
And what is a "BAS" sound?

If your question is related to the bass:
A bass line or bass phrase is usually a series of single notes (and not a series of chords). Often the lowest note of a chord is played in the bass line.

[mikael]

sorry my english is not good.

Ok what I mean is this:

when I have created my own combis, I have only one problem.

When I choose a 08 BAS timbre/sound.
For exempel: I-A125: Dark Point Bass.

I have split I-A125: Dark Point Bass to be (Top key) C3 and down to (Bottom Key) C-1.

How do I do to make it sound only on one tone, the first I
press down with my finger.

For exempel if I play the following tones:
C2, E2, G2 all three is sounding (it is terrible when all three are sounding).
But I want only C2 to sound and not E2 and G2.

Thank you

[mbncp]

You need to change the original patch and save a copy then

Go to P1:Program Basic, set Voice Assign Mode to Mono, and select Low for the Priority.

[mikael]

Thank you so much it helped...
Also I found in the P4: Zone/Delay
that I can "crossfade" that is helping also.


Thank you so much!!!