I know this is a stupid question, but I bought a Korg Triton Pro X recently, expanded with the EXB-SCSI and EXB-MOSS, and want to remove them to put them inside my Korg Triton Pro instead.
However, I have been trying but can't remove the cables that connect each expansion to another board.
Is there any trick to do so?
I don't want to force it too much not to break it and I just can't see how to do it...
Any help would be really appreciated...
How to remove an EXB-MOSS Board? I can't take it out...
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
- Rosen Sound
- Approved Merchant
- Posts: 1056
- Joined: Wed Jan 06, 2010 8:32 am
- Location: Los Angeles, California
- Contact:
it should be simple, make sure you pull ont he side of the cable thats not on the MOSS.
i found it helped to unscrew the MOSS board, then just pull it out, came out nice and smooth for me
i found it helped to unscrew the MOSS board, then just pull it out, came out nice and smooth for me
<a href="http://www.rosensound.com"><img src="https://dl.dropboxusercontent.com/u/365 ... r.jpg"></a>
Current gear: Korg Kronos 61, Oberheim OB-8, Alesis Vortex
Past Gear: Triton Extreme w/moss & ram, Korg Radias, Kurzweil Micropiano, Triton classic, & Karma
Come visit my Burbank California repair shop/recording studio! Rosensound.com
And my band: Sirion.us.com
Current gear: Korg Kronos 61, Oberheim OB-8, Alesis Vortex
Past Gear: Triton Extreme w/moss & ram, Korg Radias, Kurzweil Micropiano, Triton classic, & Karma
Come visit my Burbank California repair shop/recording studio! Rosensound.com
And my band: Sirion.us.com
I could do it the same day.
I was trying to do that for the SCSI board and that one was the hard one...
I wasn't sure what should come out with the board, so I was a bit afraid of breaking something...
But with the MOSS board, after unscrewing it, it was much easier and after doing that I just did the same with the SCSI board.
Now I just have a small problem...
I lost some of the screws and can't put the boards back on my Korg Triton...
Anyone has an idea where I can get those screws?
Thanks
Paulo
I was trying to do that for the SCSI board and that one was the hard one...
I wasn't sure what should come out with the board, so I was a bit afraid of breaking something...
But with the MOSS board, after unscrewing it, it was much easier and after doing that I just did the same with the SCSI board.
Now I just have a small problem...
I lost some of the screws and can't put the boards back on my Korg Triton...
Anyone has an idea where I can get those screws?
Thanks
Paulo