|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
ultrasteve
Joined: 05 Feb 2011 Posts: 29 Location: SE Michigan
|
Posted: Wed Mar 27, 2024 4:31 pm Post subject: Saving fast leslie in a program |
|
|
How do I save an organ program with a fast leslie already on? I still want the joystick to turn it on and off, I just want it to start while "ON".
Specifically, I want program G039 to begin with the fast leslie. |
|
Back to top |
|
|
Dan Stesco Approved Merchant
Joined: 11 Dec 2009 Posts: 639 Location: Bucharest
|
Posted: Wed Mar 27, 2024 8:57 pm Post subject: |
|
|
Tell me the program you want to change.
Usually the organ CX3 have the rotary in the engine parameter but sometimes the voicing team use IFx also.
To set the CX3 slow to fast by default:
Press Page - select CX3 - Amp/VC/Rotary SP
Select the Rotary Speaker sub Page.
Mod/Speed settings is in the upper right square.
Select the Speed SW from Slow to Fast
Write program
To set the Rotary fast by default in IFX.
Open IFX, Rotary Sp with OD
On the left side will see Speed Switch. Change the Slow to Fast.
Write Program. _________________ http://www.danstesco.ro |
|
Back to top |
|
|
ultrasteve
Joined: 05 Feb 2011 Posts: 29 Location: SE Michigan
|
Posted: Thu Mar 28, 2024 1:42 pm Post subject: |
|
|
Once again Dan, you are THE MAN!!!! You are such a wealth of knowledge! THANK YOU, THANK YOU!! |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|