|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
Drmucki
Joined: 09 Nov 2022 Posts: 2
|
Posted: Wed Nov 09, 2022 11:20 am Post subject: KORG T3 ex, Can not load PCM Data after repair |
|
|
On my T3 Ex i replaced the Display with a new LED Display. Within this procedure i also replaced all buttons and did the modifications to the power Unit (removed capacitor and transisitor to cancel the power supply for the display).
After rebuilding everything the new display and al buttons worked fine.
But then i noticed, the Oscillators above 99 were missing. I tried to load everything form the original t3 Disk i found in my Box an there i noticed that under Disk the entry for "Load all PCM Data" is missing.....
Can you tell me what could be broken, which cable/Board can be responsible for that?
Any suggestions may help!
Thank you
Marc |
|
Back to top |
|
|
Drmucki
Joined: 09 Nov 2022 Posts: 2
|
Posted: Wed Nov 09, 2022 5:10 pm Post subject: |
|
|
Solved…:
The cable from memory board to Mainboard was not plugged in….., |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|