Korg Forums

Hugo · Platinum Member Joined: 23 Jun 2006 Posts: 809

Hi guys,

I have a Triton rack, and I having problems getting the arpeggiator to output its MIDI (notes, filter sweep etc) into my rs7000.

Any tips on what I should check?
Thanks.

Sharp · Posted: Sun Sep 23, 2007 10:32 pm Post subject:

Go to the track status page of the mode your in (COMBI or Sequencer) and set the track status to BTH.

That will do the trick.

Regards.
Sharp.
_________________

Hugo · Platinum Member Joined: 23 Jun 2006 Posts: 809

Thanks a million for this info! Smile

Hugo · Platinum Member Joined: 23 Jun 2006 Posts: 809

Hmm, I didn't find neither the track status page, nor the BTH setting in Combi mode (there is no sequencer mode, as I have the Triton rack).

I checked the manual, and made sure Local Control was set to 'on' in the Global menu, as well as unchecked Echo Back on my rs7000.

Any ideas?

Sharp · Posted: Fri Sep 28, 2007 4:42 pm Post subject:

It's there, just look again.

Look for INT in COMBI mode.
This INT value can be changed to BTH.

Regards.
Sharp.
_________________

Hugo · Platinum Member Joined: 23 Jun 2006 Posts: 809

Ok, will check it out as sonn as my return home. Thanx

Hugo · Platinum Member Joined: 23 Jun 2006 Posts: 809

Well, I'm stuck. In Combi mode, 'Play' page, I see the status is 'INT', but I ca't get the cursor down to change the value. Can someone explain the procedure to me as if I was three years old? Wink

Hugo · Platinum Member Joined: 23 Jun 2006 Posts: 809

Anyone? Plz...? Wink