Korg Forums

It appears that what you're doing is right, and it should keep the setting after switching off; at least that's what mine does when I change a global parameter.

Have you tried switching the chaining of the Monologues? That could give a clue whether it's the order in the chain or whether it's tied to a particular synth.

That said, being analog in nature, th ...

Two contact points? That doesn't seem like the right point for the Peak control.

The Peak potentiometer has three contacts. First step would be to use a multimeter to check the voltages across the ...

A bit late to the party, but maybe others run into the same issue.

There are two different configurations for TRS to MIDI. Could be the wrong adapter is used.

The schematics of the Monotron Delay (which you can download from the Korg website) show that there is a series capacitor and resistor between the output opamp and the headphone jack. So, inserting a ...

I rather use the LFO in 1 shot setting, with an inversed (shift-) amount, tuning the rate to dampen the effect.

Hi synthpeter. I would like to try this workaround, but I'm not having much luck with ...

It's the same on the Monologue. It's worst with lower notes, where the impact of abruptly clamping a signal to zero is highest. Instead of using the portamento trick (which indeed mushes the notes tog ...

It's very much the same on the Monologue, its oscilloscope triggers on the start of a VCO1 cycle. By the way, it's also how a dedicated oscilloscope works, where you have a separate signal input and a ...

Did you wait after the screen went black for the panel updater to finish?

From the updater manual:

Depending on versions, the system may need to update the panel firmware when starting up. When ...

And witf does the synth always restart at the 001 patch ?? Every other bit of kit restarts where you left off...I'm not hating on this synth, but fm Korg
Must be a Korg thing; it's the same on the Mo ...

Before these settings do anything, you first need to record a motion.

Make sure that you're not in EDIT mode (press EXIT if necessary).

Set the NOTE/SLIDE/MOTION switch to MOTION, then press the ...

Do you have the Volca outputs go into a mixer with high impedance inputs, or are you passively summing them with something like a cable splitter? Volcas have trouble syncing reliably in the latter cas ...

My experience is with LMMS, but as far as I can judge, the Monologue sequencer sends the same MIDI as when you're pressing keys live (including velocity) or turning dials live (from motion sequencing) ...

Sorry if this has been discussed before. I was interested in the Minilogue XD, until I noticed something on the front panel that ruined my interest. I was sure I had seen TWO ADSRs on the original M ...

I've managed to get some convincing base-guitar and wood instrument sounds out of the Monologue, but have failed creating an electric piano sound..

There are some examples to be found for the Minil ...